Set Parameters for Loading and Unloading

It is used to set parameters for loading and unloading, so as to improve machining accuracy and efficiency.

Note: Please execute this operation in the help of the technician.

Before setting parameters for loading and unloading, make sure loading and unloading is enabled in NcConfig software.

To set parameters for loading and unloading, do the following:

1. In the upper right corner of the main interface of NcStudio software, click the hamburger menu → Load Unload Param. Load Unload Param dialog box pops up:

   

2. Double click 板材类型, and input the name for the plate type.

3. Set the following parameters according to your needs:

   • Load start / end position: the start / end position for loading material.
   • Side push position: the fixed position for side pushing.
   • Unload start / end position: the start / end position for unloading material.
   • Vacuum adsorption / destroy delay: the delay time for vacuum adsorption / destroy.
   • Loading adsorption delay: the delay time for loading adsorption.
   • Front / Left / Right / Back position delay: the delay time to turn on front / left / right / back positioning cylinder.
   • Back / Left / Right / push delay: the delay time to turn on back / left / right pushing cylinder.
   • Load / unload delay: the delay time to turn on loading / unloading cylinder.
   • Load / unload speed: the speed for loading and unloading.