Set Port Protection

The type of port protection includes the following:

• Open: the protected port automatically has a signal when the software starts.
• Close: the protected port automatically closes its signal when the software closes.
• Follow: the status of the following port is the same with that of the protected port.
• RFollow the status of the following port is different from that of the protected port.

To set port protection, do the following:

1. In Configuration page in the left, click NcStudio → Hardware Connection and Configuration, and double click Port protection. Port Protection page shows.

2. Change the ON/OFF switch of the target port in Enable column to ON status.

3. Double click the target port of Protection Type column, and select a protection type:

   

4. To save the modification, do one of the following:

   • In the menu bar, click .
   • Close Port Protection page, and click Yes in the popup.

   If the modification is not saved, sign * shows in the page name.