Set Parameters for Loading and Unloading

It is used to set parameters for loading and unloading, so as to improve machining accuracy and efficiency.

Before setting parameters for loading and unloading, make sure loading and unloading function is configured in NcConfig software.

To set parameters for loading and unloading, do the following:

1. To open Load Material page, do one of the following:

   • In Welcome page, click Load Material.
   • In the menu bar, click View → Load Material.

   

2. Set the following parameters according to your needs:

   • Load start / end position: the start / end position for loading material.
   • Side push position: the fixed position for side pushing.
   • Unload start / end position: the start / end position for unloading material.
   • Vacuum adsorption / destroy delay: the delay time for vacuum adsorption / destroy.
   • Loading adsorption delay: the delay time for loading adsorption.
   • Front / Left / Right / Back position delay: the delay time to turn on front / left / right / back positioning cylinder.
   • Back / Left / Right / push delay: the delay time to turn on back / left / right pushing cylinder.
   • Load / unload delay: the delay time to turn on loading / unloading cylinder.
   • Load / unload speed: the speed for loading and unloading.

3. In Operate area, select Load to load material / Unload to unload material / Load and Unload to load and unload material.