Do Commissioning for the Tool Magazine

Before doing commissioning for the tool magazine, make sure multi-cylinder configuration is not enabled.

To do commissioning for the tool magazine, do the following:

1. To open Magazine Setting, do one of the following:

   • In Welcome page, click Magazine Setting.
   • In the menu bar, click View → **Magazine Setting.

   

2. In Magazine Common Parameter area, set the following parameters:

   • Magazine capacity: the total number of tools in the tool magazine.
   • Speed in tool change: The spindle speed during tool change.
   • Speed of Z-axis: the speed for Z-axis moving to the upper / lower position during tool change.
   • Magazine cylinder delay: the delay time to turn on the magazine cylinder.
   • Spindle tool clamp delay: the delay time to clamp / unclamp tool.
   • Dustcover cylinder delay: the delay time for the dustcover up and down.
   • X safe position: it is used to set the X-axis protection position by judging if the current X-axis position is less than the X-axis position of the tool magazine when the tool magazine is pushed out.

3. To set the current position of tool magazine, in Magazine Tools Position area, click Set.

4. Optional: To replace the current tool, in Change Tool Test area, click the dropdown box of Active tool number, select the target tool number, and click Change.