| G00 |
Rapid Positioning |
G68 |
Coordinate System Rotation |
| G01 |
Linear Interpolation |
G69 |
Cancelling Coordinate System Rotation |
| G02 |
Circular Interpolation (clockwise) |
G20 |
Input in Inch |
| G03 |
Circular Interpolation (counterclockwise) |
G21 |
Input in mm |
| G04 |
Dwell |
G73 |
High-speed Peck Drilling Cycle for Deep Holes |
| G17 |
XY Plane Selection |
G74 |
Left Tapping Cycle |
| G18 |
ZX Plane Selection |
G76 |
Fine Boring Cycle |
| G19 |
YZ Plane Selection |
G80 |
Cancelling Canned Cycle |
| G70 |
Input in Inch |
G81 |
Drilling Cycle |
| G71 |
Input in mm |
G82 |
Drilling Cycle of Dwell at the Bottom of Hole |
| G28 |
Automatic Returning to Reference Point |
G83 |
Peck Drilling Cycle for Deep Holes |
| G34 |
Circle Drilling Cycle |
G84 |
Tapping Cycle |
| G35 |
Linear Drilling Cycle |
G85 |
Drilling Cycle |
| G36 |
Arc Drilling Cycle |
G86 |
High-speed Drilling Cycle |
| G37 |
Chessboard Drilling Cycle |
G87 |
Fine Back Boring Cycle |
| G40 |
Cancel Tool Radius Compensation |
G88 |
Boring Cycle |
| G41 |
Left Tool Radius Compensation |
G89 |
Boring Cycle of Dwell at the Bottom of Hole |
| G42 |
Right Tool Radius Compensation |
G90 |
Absolute Programming |
| G43 |
Tool Length Positive Compensation |
G91 |
Incremental Programming |
| G44 |
Tool Length Negative Compensation |
G92 |
Setting Workpiece Coordinate System |
| G49 |
Cancel Tool Length Compensation |
G903 |
100% Feedrate Override Command |
| G50 |
Scaling Off |
G904 |
Conditional Movement Command |
| G51 |
Scaling On |
G905 |
Enable Feedrate Command |
| G50.1 |
Mirroring Off |
G906 |
Synchronization Command |
| G51.1 |
Mirroring On |
G907 |
Moving in the Shortest Path |
| G53 |
Machine Coordinate System |
G908 |
Force to Program in Degrees |
| G54 |
WCS 1 |
G916 |
Writing Axis Configuration Data Command |
| G55 |
WCS 2 |
G918 |
Clearing Latch Flag Command |
| G56 |
WCS 3 |
G919 |
Calculating Deceleration Distance of Cross-signal Trigger Point |
| G57 |
WCS 4 |
G921 |
Specifying the Workpiece Coordinates of Current Point |
| G58 |
WCS 5 |
G922 |
Specifying the Coordinates of WCS Origin |
| G59 |
WCS 6 |
G923 |
Setting Tool Offset |
| G65 |
Subprogram Call |
G992 |
Setting Temporary WCS |