Register the Software

It is used to restrict the system usage time.

Before registering the software, make sure the machine tool is in idle or E-stop status.

To register the software, do the following:

  1. Get a registration code.

  2. Register the software with a registration code.

After registering the software, check the remaining registration time in NcStudio dialog box.

Get a Registration Code

Before getting a registration code, do the following:

  1. To get an account, do one of the following:

    • Contact local sales.
    • Dial 400-882-9188.

  2. Fill in Registration Information Confirmation Letter and send it to Weihong Company after sealing it.

    Weihong Company will put the information on file.

To get a registration code, do the following:

  1. To open NcStudio dialog box, in the menu bar, click Help → About:

  2. Record the device number.

    The last three digits of the device number vary with the registration times:

    Registration Times Last Three Digits
    0 000
    1 001
    ... ...

  3. To enter into WEIHONG official account in WeChat, scan the QR code on the lower left.

  4. To get a temporary password, click Service → Register, fill in the blanks and click Activate Account.

    Note: The temporary password will be sent to the registered mobile phone.

  5. Return to Log in page, fill in the blanks, enter the temporary password, and fill in related information in Time Registration page:

To reset the password, click .

Register the Software with a Registration Code

To register the software with a registration code, do the following:

  1. To open NcStudio dialog box, in the menu bar, click Help → About.

  2. Click Register. Register dialog box pops up:

  3. Enter the registration code in Register code input box.

Restart the software to make registering effective.

If the software expired, a prompt The software is overdue. Please register! pops up after the software is started. At this time, please register the software again.

If the motion control card and the software do not match, a prompt Board class error. Please register! pops up. At this time, please contact the manufacturer.