Overview

This section introduces the hardware and software of the NcStudio V15 laser cutting control system.

• Hardware

  • PM95A motion control card
  • Lambda controller
    • Non-bus control systems: Lambda 5E controller
    • Bus control systems: Lambda NE controller
  • EX33A extension terminal board (for follow control)
  • EX31A extension terminal board (for extension of terminal board ports)
  • SE001 follow-up amplifier
  • DB9M/F communication cables * 2
  • RF cable * 1
  • M16 three-core aviation plug towline cable * 1
  • WHB05L wireless handwheel / WHB05N wireless handwheel

  For hardware connection diagram, see Hardware Connection Diagram.

• Software

  For introduction of the software interface of the NcStudio V15 laser cutting control system, see Software Interface.