Wiring Diagram of Terminal Board

In this section, you can quickly know about how to connect I/O ports of each terminal board.

According to the configuration, wiring diagram of terminal board can be divided into the following:

Terminal board differs in follow-up control mode:

  • In position loop control mode, the terminal board is EX30A terminal board.
  • In velocity loop control mode, the terminal board is EX33A terminal board.

To enable exchanging workbench function, EX31A terminal board must be added.

Wiring Diagram of Terminal Board (in Sheet Cutting Configuration)

In sheet cutting configuration, wiring diagram of terminal board includes the following:

Wiring Diagram of Lambda 5E Terminal Board

In double Y configuration, wiring diagram of Lambda 5E terminal board in position loop control mode is as follows:

Wiring diagram in velocity loop control mode differs from that in position loop control mode in that:

  • Port Connected to Z-axis driver is not connected.
  • The connected terminal board is EX33A.

Wiring diagram in single Y configuration differs from that in double Y configuration in that:

  • X-axis, Y-axis and Z-axis servo interfaces should be connected to axis servo interfaces 1, 2 and 4.
  • Port X08 is the origin of Y-axis and port X09 is general input port.

Wiring Diagram of EX30A Terminal Board

Wiring diagram of EX30A terminal board is as follows:

Among the ports:

  • The outputs of EX30A terminal board are Darlington outputs and their load current cannot be more than 0.4A.
  • Outputs Y00~Y05 should be conneted to relays.
  • In configuration with follow-up, Y02 is set as Blow (Air).
  • In configuration without follow-up, Y02 is set as Follow Control Switching.

Wiring Diagram of EX33A Terminal Board

Wiring diagram of EX33A terminal board is as follows:

Among the ports:

  • Outputs Y00~Y05 should be conneted to relays.
  • In configuration with follow-up, Y02 is set as Blow (Air).
  • In configuration without follow-up, Y02 is set as Follow Control Switching.

Wiring Diagram of EX31ATerminal Board

Wiring diagram of EX31A terminal board is as follows:

Among the ports:

  • C00~C05 are common ports.
  • Y04~Y09 are reserved output ports.
  • S00~S03 are active high/low ports.

Wiring Diagram of Terminal Board (in Tube Cutting Configuration)

In tube cutting configuration, wiring diagram of terminal board includes the following:

Wiring Diagram of Lambda 5E Terminal Board

Wiring diagram of Lambda 5E terminal board in position loop control mode is as follows:

Wiring diagram in velocity loop control mode differs from that in position loop control mode in that:

  • Port Connected to Z-axis driver is Connected to W-axis driver.
  • The connected terminal board is EX33A.

Wiring Diagram of EX30A Terminal Board

Wiring diagram of EX30A terminal board is as follows:

Wiring Diagram of EX33A Terminal Board

Wiring diagram of EX33A terminal board is as follows:

Wiring Diagram of EX31A Terminal Board

Wiring diagram of EX31A terminal board is as follows: