维宏LOGO
Search Results for

    Show / Hide Table of Contents

    WH108C Operation Panel

    This part introduces the layout and mounting dimension of WH108C operation panel used by NK300CX-V.

    Layout

    The front view of the operation panel is as follows:

    1. Alpha-numeric keys

      Used to input characters and numbers. Its use is generally the same with that of the computer keyboard:

      • Press an alphabet key to enter the alphabet on the right-lower part.
      • Press Shift key and an alphabet key to enter the alphabet on the left-upper right.
    2. Keys for common operations

      Used to enable frequently used operations

      Including ATC CW, ATC CCW, ATC OUT, Unclamp, Reset, Simulate, Single Block and HW Guide keys.

    3. Keys for common ports

      Used to turn on / off frequently used ports.

      Including Air, Light, Coolant, Oil keys, and control rapid movement, including Rapid key.

    4. Keys for mode selection

      Used to select a machining mode among REF.Point, JOG, Auto, Handle and Step.

      JOG, Handle and Step modes are referred as Manual mode.

    5. Extension keys

      Used to customize extension functions

      Including K1, K2, K3 and K4 keys.

      In Integrated CNC System for Shoe Molding Machines, K1 key is used as an air brake key for frock clamp. Before each machining, the system will judge whether the fixture is clamped. Only when it is clamped, the system will start machining. Otherwise, a yellow alarm occurs.

    6. Keys for spindle control

      Used to control the spindle movement, including CW, Stop and CCW keys.

    7. E-stop switch

      Used to stop the movement of the machine tool when the machine tool is in danger, so as to protect the operator and machine tool.

      After the danger is cleared, you can rotate the switch clockwise to remove the E-stop alarm.

    8. Keys for axis direction

      Used to manually move each axis.

      In Manual mode:

      • Press an axis direction key and Rapid key at the same time. The axis moves at rapid jog speed.
      • Press an axis direction key. The axis moves at jog speed.
    9. Power Switch

      Used to control power on or off.

    10. Keys for movement control

      Used to control the movement of the machine tool, including START, STOP, Pause, and Resume keys.

    11. Spindle override knob

      Used to adjust spindle override from 50% to 150%.

      When parameter N72003 G00 F Fixed is set to No, the knob is used as G00 override knob and used to adjust G00 override from 0% to 100%.

    12. Feed override knob

      Used to adjust feed override from 0% to 120%.

    Mounting Dimension (Unit: mm)

    WH108C Dimension

    WH108C Cut-out

    In This Article
    Back to top Shanghai Weihong Electronic Technology Co., Ltd.