Wiring and IO configuration
NcStudio V10 CCD System uses Lambda 3S controller.
See figure below for wiring and IO ports of Lambda 3S.
Table below describes details of 7 input and 5 output ports.
- X__ represents input ports
- Y__ represents output ports
| PIN | Address | Description |
|---|---|---|
| X00 | 00100 | Negative limit in X-axis, also used as origin switch |
| X01 | 00101 | Negative limit in Y-axis, also used as origin switch |
| X02 | 00102 | Positive limit in Z-axis, also used as origin switch |
| X03 | 00103 | Emergency stop |
| X04 | 00104 | Tool sensor signal |
| X05 | 00105 | Vacuum pressure alarm signal |
| X06 | 00106 | Spindle alarm |
| Y00 | 10016 | Spindle ON |
| Y01 | 10017 | Vacuum pump |
| Y02 | 10018 | Lube |
| Y03 | 10019 | Light source |
| Y04 | 10020 | Reserved for customization |