Execute Simulation

This operation helps to know the machining track in advance, so as to avoid damages to the machine tool caused by programming mistakes.

Before executing simulation, ensure the program file has been loaded.

To execute simulation, do one of the following:

Execute Simulation by the System

Through this operation, NcStudio V10 Waterjet Cutting Control System does not drive the machine tool and only displays the toolpath in POS window, and you can visually check the machining program.

To execute the simulation by the system, do one of the following:

  • Click Operate → Simulation Mode.

  • In Auto mode, in operation button bar, click Simmu → Start.

The system automatically executes simulation. And shows in the upper left corner of POS window.

Execute a Trial by the Machine Tool

Through this operation, NcStudio V10 Waterjet Cutting Control System will drive the machine tool, and you can check coordinates of the machine tool and the toolpath in POS window.

In the area of valve control, click Simulate → Start. The trial automatically starts.